EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Leak Check Valve Assembly
ASSEMBLY
1. Install the bracket to the leak check valve assembly.
Tightening torque:
18 N·m (1.8 kgf-m, 13.3 ft-lb)
2. Install the drain tube to the leak check valve assembly.
CAUTION:
• Check that there is no damage or dust on the quick connector. If necessary, clean the seal surface of the pipe.
• Make sure that the quick connector is securely connected.
NOTE:
Connect the quick connector as shown in the figure.
3. Install the drain separator to the leak check valve assembly. Drain Separator > INSTALLATION">
Installation
REAR SUSPENSION > Rear StabilizerINSTALLATIONCAUTION:• Be sure to use a new flange nut and self-locking nut.• Always tighten the bushing in the state where the vehicle is at curb weight and the wheels are in full contact with the ground.• Install the clamp - stabilizer bushing w ...
ECO history screen
Average fuel consumption per unit time
(bar graph)
Average fuel consumption corresponding
to the driving distance of each trip meter
(red line)
This screen displays the fuel economy
history for the vehicle using a bar graph.
The horizontal scale represents the past
time range ...
Adjustment
WIPER AND WASHER SYSTEMS > Front Washer Nozzle and HoseADJUSTMENT1. NOZZLE - WINDSHIELD WASHER1. Turn the wiper switch to OFF position.2. While the vehicle is at a standstill, insert a precision screwdriver (A) or equivalent wrapped with protective tape into the clearance on the upper/lower side ...