CONTROL SYSTEMS > Select Lever
ASSEMBLY
1. Clean all the parts before assembly.
2. Apply Multemp D or equivalent to the sliding portion of each part.
3. Assemble in the reverse order of disassembly.
NOTE:
Insert the solenoid unit terminals to the harness connector.
(A) | Solenoid unit (color code: blue) |
(B) | Solenoid unit (color code: black) |
4. After installation, check the following points.
• The select indicator matches the select lever position when the select lever is changed from “P” range to “D” range.
• The select lever position and the position mark match each other.
• Operating force to move the select lever from “P” to “D” range
Removal
SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF) > Sunroof MotorREMOVAL1. Completely close the lid assembly - sunroof.2. Disconnect the ground cable from battery. NOTE">3. Remove the light assembly - map. (Models without EyeSight) Spot Map Light > REMOVAL">4. Remove the stereo camera ...
Installation
EXTERIOR/INTERIOR TRIM > Roof MoldingINSTALLATION1. Remove the clips from the molding - roof, and attach to the studs on the vehicle.CAUTION:• Always replace the clips that were damaged during removal of the molding - roof with new parts.• While installing the molding - roof, be caref ...
Dtc u0416 invalid data received from vehicle dynamics control module
LAN SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0416 INVALID DATA RECEIVED FROM VEHICLE DYNAMICS CONTROL MODULEDTC DETECTING CONDITION:Data from VDCCM is faulty.TROUBLE SYMPTOM:ABS warning light and VDC warning light illuminate.STEPCHECKYESNO1.CHECK PERFORMI ...