Subaru Crosstrek Service Manual: Assembly

1. Face the O-ring side of the CVTF filter to the transmission case side, and install the CVTF filter.

NOTE:

Apply CVTF to the O-ring of CVTF filter.

2. Install the CVTF filter cover and gasket.

NOTE:

Use a new gasket.

Tightening torque:

17 N·m (1.7 kgf-m, 12.5 ft-lb)

3. Using the ST, install the oil seal.

NOTE:

• Use a new oil seal.

• Apply CVTF to the oil seal lip and press-fitting surface.

4. Using ST1 and ST2, install the ball bearing on the reduction driven gear side.

NOTE:

Use a new ball bearing.

5. Install the oil guide.

6. Press-fit the roll pin into the ball bearing on the secondary pulley side.

(1) Hold the roll pin with a knock pin punch or the like, and press-fit with a hammer.

NOTE:

• Use a new ball bearing.

• When securing the ball bearing with a vise, place a wood piece therebetween to avoid scratching the bearing race.

(2) Measure the height “A” of the roll pin.

Specification:

4.4 mm (0.173 in) or less

7. Using ST1, ST2 and ST3, install the ball bearing on the secondary pulley side.

NOTE:

• Align the roll pin to the cutout of the transmission case.

• Press-fit the pin so that it is positioned on near side (the retainer should be seen on your side).

8. Install all plugs.

NOTE:

• Use new O-rings.

• Apply CVTF to the O-rings.

• For the plug (A), fill the CVTF, and then tighten the plug using a new O-ring.

Tightening torque:

T1: 13 N·m (1.3 kgf-m, 9.6 ft-lb)

T2: 22 N·m (2.2 kgf-m, 16.2 ft-lb)

T3: 50 N·m (5.1 kgf-m, 36.9 ft-lb)

9. Install the oil stopper plate.

NOTE:

Use a new bolt.

Tightening torque:

9 N·m (0.9 kgf-m, 6.6 ft-lb)

Removal

Disassembly

Other materials:

Preparation tool
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS — SUBARU SELECT MONITOR 4Used for setting of each function and troubleshooting for electrical system.NOTE:For detailed operation procedures o ...

Cleaning aluminum wheels
Promptly wipe the aluminum wheels clean of any kind of grime or agent. If dirt is left on too long, it may be difficult to clean off. Do not use soap containing grit to clean the wheels. Be sure to use a neutral cleaning agent, and later rinse thoroughly with water. Do not clean the ...

Tire pressures and wear
Maintaining the correct tire pressures helps to maximize the tires' service lives and is essential for good running performance. Check and, if necessary, adjust the pressure of each tire (including the spare - if equipped) at least once a month (for example, during a fuel stop) and before a ...