Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Assembly

CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Extension Case

ASSEMBLY

1. Press-fit the dust cover into extension case.

2. Install the extension case oil seal to extension case. Differential Side Retainer Oil Seal > REPLACEMENT">

3. Install all plugs.

NOTE:

Use a new O-ring or a gasket.

Apply CVTF to the O-rings.

Tightening torque:

T1: 22 N·m (2.2 kgf-m, 16.2 ft-lb)

T2: 35 N·m (3.6 kgf-m, 25.8 ft-lb)

Removal
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Extension CaseREMOVAL1. Remove the transmission assembly from the vehicle. Automatic Transmission Assembly > REMOVAL">2. Remove the extension ...

Disassembly
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Extension CaseDISASSEMBLY1. Remove the dust cover from extension case.2. Remove the extension case oil seal from the extension case. Differential Side R ...

Other materials:

Inspection
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Mass Air Flow and Intake Air Temperature SensorINSPECTION1. CHECK THE MASS AIR FLOW SENSOR UNIT1. Connect the battery positive terminal to terminal No. 3 and the battery ground terminal to terminal No. 4, the circuit tester positive terminal to terminal No. 5 ...

Specification
IGNITION(H4DO) > General DescriptionSPECIFICATIONItemSpecificationsIgnition coilManufacturer and typeHitachi: EIC-2230Ignition systemIndependent ignition coilSpark plugManufacturer and typeNGK: SILZKAR7B11Thread size (diameter, pitch, length)mm12, 1.25, 26.5Spark plug gapmm (in)Standard1.0 — 1. ...

Locking the doors
Press the lock/arm button to lock all doors and rear gate. An electronic chirp will sound once and the hazard warning flashers will flash once. If any of the doors (or the rear gate) is not fully closed, the following will occur to alert you that the doors (or the rear gate) are not properl ...

© 2016-2022 Copyright www.sucross.com