CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Converter Case
ASSEMBLY
1. Install the oil drain plug.
Tightening torque:
70 N·m (7.1 kgf-m, 51.6 ft-lb)
2. Install the overflow drain plug.
NOTE:
Overflow plug of differential gear oil is temporarily attached.
3. Install all plugs.
NOTE:
Use new O-rings.
Tightening torque:
T1: 22 N·m (2.2 kgf-m, 16.2 ft-lb)
T2: 22.5 N·m (2.3 kgf-m, 16.6 ft-lb)
4. Install the pitching stopper bracket and transmission radio ground cord.
CAUTION:
Be careful not to deform or damage the terminal of transmission radio ground cord.
Tightening torque:
41 N·m (4.2 kgf-m, 30.2 ft-lb)
Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Crankshaft Position SensorREMOVAL1. Disconnect the ground cable from battery.2. Remove the clip (A), and loosen the clamps (B) and (C) securing the air intake boot.3. Remove the air intake boot from the air cleaner case (rear) and throttle body, and move the ...
Installation
AIRBAG SYSTEM > Roll ConnectorINSTALLATIONCAUTION:If the steering wheel and steering angle sensor (steering roll connector) are removed, be sure to perform the following operations.• Align the center position of the steering roll connector.• Perform the neutral position setting of the ...
Installation
MECHANICAL(H4DO) > Rocker CoverINSTALLATION1. ROCKER COVER RH1. Install the #1 spark plug pipe gasket and #3 spark plug pipe gasket to the #1 spark plug pipe and #3 spark plug pipe.NOTE:• Use a new #1 spark plug pipe gasket and #3 spark plug pipe gasket.• Apply a light coat of engine ...