Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Assembly

CLUTCH SYSTEM > Operating Cylinder

ASSEMBLY

NOTE:

During assembly, apply hydraulic oil to all parts.

Recommended brake fluid:

New FMVSS No. 116 DOT3 or DOT4

1. Install the piston spring.

2. Insert piston into the operating cylinder.

3. Install push rod to the boot.

4. Install the boot and push rod.

Operating cylinder
...

Removal
CLUTCH SYSTEM > Operating CylinderREMOVALCAUTION:Brake fluid spilled on the vehicle body will harm the paint surface; therefore, wash it off with water and wipe clean quickly if spilled.1. Disconne ...

Other materials:

Dtc b1000 airbag ecu malfunction
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1000 AIRBAG ECU MALFUNCTIONDIAGNOSIS START CONDITION:Ignition voltage is 10 V to 16 V.DTC DETECTING CONDITION:Airbag control module is faulty.CAUTION:Before performing diagnosis, refer to “CAUTION” in “General ...

Control unit Note
EyeSight > Control UnitNOTESystem control of the EyeSight is performed by each module. For procedure, refer to the following sections.• Engine control module (ECM): Engine Control Module (ECM)">• Transmission control module (TCM): Transmission Control Module (TCM)">& ...

Installation
ENTERTAINMENT > Data Communication ModuleINSTALLATION1. DATA COMMUNICATION MODULECAUTION:• After installing the center grille assembly, check that the air vent grille of the center grille assembly is inserted correctly into the air vent duct.• Before handling the airbag system compone ...

© 2016-2026 Copyright www.sucross.com