CLUTCH SYSTEM > Master Cylinder
ASSEMBLY
1. Apply a coat of grease to the contact surfaces of the push rod and piston before installation.
Grease:
SILICONE GREASE G-40M or equivalent

2. Assemble in the reverse order of disassembly.
Tightening torque:
10 N·m (1.0 kgf-m, 7.4 ft-lb)
Master cylinder
RemovalInstallation
AIRBAG SYSTEM > Front Sub SensorINSTALLATIONCAUTION:• If the airbag has been activated, replace the front sub sensor with a new part.• Do not reuse the bolt and nut.Always replace with the specified new bolts and nuts.• When installing the sensor, insert the set pin on the backs ...
Inspection
WIPER AND WASHER SYSTEMS > Wiper and Washer SystemINSPECTIONSymptomsRepair orderWiper and washers do not operate.(1) Wiper fuse (F/B No. 14, 15)(2) Combination switch(3) Motor assembly - wiper(4) Wiring harnessWipers do not operate in LO or HI.(1) Combination switch(2) Motor assembly - wiper(3) W ...
Inspection
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Front Oxygen (A/F) SensorINSPECTION1. Check that the front oxygen (A/F) sensor has no deformation, cracks or other damages.2. Measure the resistance between front oxygen (A/F) sensor terminals.Terminal No.Standard1 and 22.0+0.42 −0.2 ? (when 20� ...