Subaru Crosstrek Service Manual: Assembly
CLUTCH SYSTEM > Clutch Pedal
ASSEMBLY
1. Install the stopper and pedal pad to the clutch pedal.
2. Install the clutch switch to the pedal bracket.
3. Clean the pedal bushing holes of the clutch pedal and the brake pedal, apply grease, and install the pedal bushings.
4. Install the clutch pedal, brake pedal and lever to the pedal bracket, and fix with a spring pin.
5. Install the assist rod A, assist rod B, assist bushing and assist spring to the clutch pedal and pedal bracket.
Removal
CLUTCH SYSTEM > Clutch PedalREMOVALCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General ...
Disassembly
CLUTCH SYSTEM > Clutch PedalDISASSEMBLY1. Remove the clutch switches.2. Remove the clip, assist spring, rod and bushing.(A)Clip(B)Assist spring(C)Assist rod(D)Bushing(E)Clevis pin3. Remove the spri ...
Other materials:
Caution
POWER ASSISTED SYSTEM (POWER STEERING) (DIAGNOSTICS) > General DescriptionCAUTION1. SRS AIRBAG SYSTEMThe airbag system wiring harness is routed near the power steering control module.CAUTION:• Do not use the electrical test equipment on the airbag system wiring harnesses or connector circui ...
Dtc b2275 engine start request control circuit
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2275 ENGINE START REQUEST CONTROL CIRCUITDTC detecting condition:• When malfunction is detected in engine start permission signal output circuit in the keyless access CM. ...
Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Camshaft Position SensorREMOVAL1. INTAKE SIDE1. Disconnect the ground cable from battery.2. Remove the air intake duct. (RH side only) Air Intake Duct > REMOVAL">3. Disconnect the connector (A) from the camshaft position sensor, and remove the cam ...
