Subaru Crosstrek Owners Manual: Arming the system
- Tips
- To arm the system using access key/remote transmitter
- To arm the system using power door locking switches
- To arm the system using the keyless access function (if equipped)
If you have accidentally triggered the alarm system
To stop the alarm
Do any of the following operations
Press any button on the access key/
remote transmitter.
Turn the ignition switch to the "ON"
position (models without "keyless access
...
Tips
The system can be armed even if the
engine hood, windows and/or moonroof
are open. Always make sure that they are
fully closed before arming the system.
The 30-second standby time can be
...
Other materials:
Inspection
LUBRICATION(H4DO) > Engine Oil FilterINSPECTION1. After installing the oil filter, run the engine and check for oil leakage.NOTE:The filter element and filter case are permanently jointed; therefore, interior cleaning is not necessary.2. Check the engine oil level. Engine Oil > INSPECTION&quo ...
Removal
DRIVE SHAFT SYSTEM > Rear AxleREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Lift up the vehicle, and then remove the rear wheels.3. Remove the axle nut.CAUTION:Do not loosen the axle nut while the rear axle is loaded. Doing so may damage the hub unit bearing.(1) Lift the c ...
Dtc b2300 rear radar circuit low
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2300 REAR RADAR CIRCUIT LOWDTC detecting condition:• Short circuit to ground in the harness between radar sensor and outer mirror assembly• Ground short circuit of ...
