Subaru Crosstrek Owners Manual: All-Wheel Drive warning light (CVT models)
This
light blinks if the vehicle is driven with
tires of differing diameters fitted on the
wheels or with an excessively low air
pressure in any of the tires.
WARNING
If the AWD warning light flashes, promptly park in a safe location then check whether all four tires are the same diameter and whether any of the tires has a puncture or has lost air pressure for some other reason.
Continuing to drive with the AWD warning light flashing can lead to powertrain damage.
Door open warning light
The
warning light illuminates if any door
(including the rear gate) is not fully closed.
This function is effective even if the
ignition switch is in the "LOCK"/"OFF" or
"ACC" position, or t ...
Power steering warning light
This
warning light illuminates when the
ignition switch is turned to the "ON"
position and turns off after the engine
has started. This indicates that the warning
system is working properly.
...
Other materials:
Removal
EXTERIOR/INTERIOR TRIM > Center ConsoleREMOVAL1. Remove the center grille assembly. Air Vent Grille > REMOVAL">2. Remove the audio assembly or navigation assembly. Audio > REMOVAL"> ...
Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > CVTF FilterINSTALLATIONNOTE:For installation of CVTF filter, refer to “Transmission Case”. Transmission Case > ASSEMBLY"> Transmission Case > INSTALLATION"> ...
Canceling the function for meter/gauge needle movement upon turning on the
ignition switch
It is possible to activate or deactivate the
movement of the meter needles and
gauge needles that takes place when the
ignition switch is turned to the "ON"
position.
Type A combination meter
To change the setting, perform the following
procedure.
1. Turn the ignition switch to the "LOCK"/ ...
