The alarm system helps to protect your vehicle and valuables from theft. The horn sounds and the hazard warning flashers flash if someone attempts to break into your vehicle.
For models with "keyless access with push-button start system": The system can be armed or disarmed with the keyless access function or access key.
The system will not be activated when the push-button ignition switch is in the "ACC" or "ON" position.
For models without "keyless access with push-button start system": The system can be armed or disarmed with the remote transmitter.
The system will not be activated when the key is inserted into the ignition switch.
Your vehicle's alarm system has been set for activation at the time of shipment from the factory. You can set the system for deactivation yourself or have it done by your SUBARU dealer.
Removal
LIGHTING SYSTEM > High-mounted Stop LightREMOVAL1. CROSSTREK MODEL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear gate UPR. Rear Gate Trim > REMOVAL">3. Remove the light assembly - high-mounted.(1) Remove the nut.(2) From the inside of the r ...
Removal
CLUTCH SYSTEM > Clutch Pipe and HoseREMOVAL1. Disconnect the ground cable from battery.2. Remove the clip (A) from the air intake boot.3. Loosen the clamp (B) connecting the air intake boot and air cleaner case (rear).4. Loosen the clamp (C) which connects the air intake boot and throttle body.5. ...
Dtc b1698 door sensor lh initialization incomplete
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1698 DOOR SENSOR LH INITIALIZATION INCOMPLETEDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Open or short circuit in harness of side sensor bus (LH)• Front door impact sensor (LH ...