Subaru Crosstrek Owners Manual: Airflow mode selection
To select the airflow mode: Type A, B and C: Turn the airflow mode selection dial.
Type D: Press the airflow mode selection button.
To select the defrost mode: Type A and B: Turn the airflow mode selection dial.
Type C and D: Press the defroster button.
Airflow modes are as follows.
(Ventilation): Instrument panel outlets
(Bi-level): Instrument panel outlets and foot outlets
(Heat): Foot outlets, both side outlets of the instrument panel and some through windshield defroster outlets (A small amount of air flows to the windshield and both side windows to prevent fogging.)
(Heat-def): Windshield defroster outlets, foot outlets and both side outlets of the instrument panel (Refer to "Defrosting" F4-11.)
(Defrost): Windshield defroster outlets and both side outlets of the instrument panel (Refer to "Defrosting"
Temperature control
Type A
Turn the temperature control dial over a
range from the blue side (cool) to red side
(warm) to regulate the temperature of
airflow from the air outlets.
Type B, C and D
Turn the temperatu ...
Other materials:
Dtc u0122 lost communication with vehicle dynamics control module
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0122 LOST COMMUNICATION WITH VEHICLE DYNAMICS CONTROL MODULEDetected when CAN data from VDC CM does not arrive.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Pro ...
Changing a flat tire
WARNING
Do not jack up the vehicle on an
incline or a loose road surface.
The jack can come out of the
jacking point or sink into the
ground and this can result in a
severe accident.
Use only the jack provided with
your vehicle. The jack supplied
with the vehicle is designed on ...
Assembly
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Reverse Brake AssemblyASSEMBLY1. Install the reverse brake piston.NOTE:Apply CVTF to the sealing area of reverse brake piston.2. Install the return spring.3. Install the spring retainer.4. Compress the return spring using the ST to install the snap ring ...
