Subaru Crosstrek Service Manual: Airbag warning light remains on

Detecting condition:

• Airbag warning light is faulty.

• Airbag control module to combination meter circuit is shorted or open.

• Grounding circuit is faulty.

• Airbag control module is faulty.

• Connector connection is improper.

• Connections of (AB6, AB17, AB18) to airbag control module are improper.

Before performing diagnosis, refer to “CAUTION” in “General Description”. General Description > CAUTION">

1.CHECK CAN COMMUNICATION.

Inspect LAN system. Basic Diagnostic Procedure > PROCEDURE">

Is there any fault?

Repair it according to diagnosis of LAN system.

Airbag Warning Light Failure > AIRBAG WARNING LIGHT REMAINS ON">Go to Step 2.

2.CHECK DTC.

1) Turn the ignition switch to OFF, disconnect the battery ground cable, and wait for 60 seconds or more.

2) Check the connection status of airbag CM connector.

Is there poor contact of connector?

Reconnect the connector. Or repair the connector.

Airbag Warning Light Failure > AIRBAG WARNING LIGHT REMAINS ON">Go to Step 3.

3.CHECK FOR POOR CONTACT.

Check the combination meter. Basic Diagnostic Procedure > PROCEDURE">

Is there any fault?

Repair it according to INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS).

Replace the airbag CM. Airbag Control Module > REMOVAL">

Airbag warning light remains off

Diagnostic chart with trouble code

Other materials:

Dtc u0101 lost communication with tcm
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0101 LOST COMMUNICATION WITH TCMDetected when CAN data from TCM does not arrive.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROCEDURE"> ...

Trailer hitch (dealer option)
WARNING Never exceed the maximum weight specified for the trailer hitch. Exceeding the maximum weight could cause an accident resulting in serious personal injuries. Permissible trailer weight changes depending on the situation. For possible recommendations and limitations, r ...

Installation
WIPER AND WASHER SYSTEMS > Front Wiper ArmINSTALLATION1. MODELS WITHOUT EyeSight1. Install the arm assembly - windshield wiper.(1) Assemble the arm assembly - windshield wiper so that the blade assembly - windshield wiper is aligned to the ceramic print point mark of the windshield glass.(2) Tigh ...