Subaru Crosstrek Service Manual: Airbag system
- Airbag control module
- Curtain airbag module
- Curtain airbag sensor
- Driver s airbag module
- Front door impact sensor
- Front sub sensor
- General description
- Knee airbag module
- Passenger s airbag module
- Roll connector
- Satellite safing sensor
- Side airbag module
- Side airbag sensor
- Airbag connector Procedure
- Airbag module disposal (deployment processing on vehicle) Procedure
- Inspection locations after a collision Inspection
Read diagnostic trouble code (dtc) Operation
AIRBAG SYSTEM (DIAGNOSTICS) > Read Diagnostic Trouble Code (DTC)OPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and ...
Other materials:
Inspection
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Rear Oxygen SensorINSPECTION1. Check that the rear oxygen sensor has no deformation, cracks or other damages.2. Measure the resistance between rear oxygen sensor terminals.Terminal No.Standard1 and 25.6+1.7 −0.6 ? (when 20°C (68°F) ...
Installation
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Knock SensorINSTALLATION1. Install the knock sensor to the cylinder block.NOTE:The knock sensor should be installed so that the center of the connector is positioned at a 76.5 — 91.5° angle relative to the front of engine.Tightening torque:24 N&m ...
Rear window wiper blade rubber
1. Pull out the end of the blade rubber
assembly to unlock it from the plastic
support.
2. Pull the blade rubber assembly out of
the plastic support.
1) Metal spines
3. If the new blade rubber is not provided
with two metal spines, remove the metal
spines from the old blade rubbe ...
