Subaru Crosstrek Service Manual: Airbag control module i/o signal
Electrical specification
AIRBAG SYSTEM (DIAGNOSTICS) > Airbag Control Module I/O SignalELECTRICAL SPECIFICATION• Terminal numbers in airbag control module connector are shown in the figure.• The airbag warning ...
Other materials:
Inspection
DRIVE SHAFT SYSTEM > Rear Drive ShaftINSPECTIONCheck the removed parts for damage, wear, corrosion etc. Repair or replace if defective.• DOJ (Double Offset Joint):Check for seizure, corrosion, damage, wear and excessive play.• BJ (Bell Joint):Check for seizure, corrosion, damage and e ...
Electrical specification
LAN SYSTEM (DIAGNOSTICS) > Control Module I/O SignalELECTRICAL SPECIFICATION• Body integrated unitFor I/O signals of the body integrated unit, refer to BODY CONTROL SYSTEM (DIAGNOSTICS). Control Module I/O Signal">• Engine CMFor I/O signals of ECM, refer to ENGINE (DIAGNOSTIC ...
Dtc b2a0e mute line circuit
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2A0E MUTE LINE CIRCUITDiagnosis start condition:When ignition switch is ON.DTC detecting condition:Any of the following conditions occurs continuously for five seconds or more after the ignition switch i ...
