OCCUPANT DETECTION SYSTEM (DIAGNOSTICS) > Airbag Connector
PROCEDURE
1. OCCUPANT DETECTION SYSTEM (BETWEEN AIRBAG REAR HARNESS AND SEAT HARNESS)
1. How to disconnect:
Press the lock arm (A) and disconnect the connector.
CAUTION:
When pulling the slide lock or disconnecting connector, be sure to hold the connector, not the harness.
2. How to connect:
Holding the connector, push it in securely until a clicking sound is heard.
CAUTION:
Be sure to insert the connector in until it is locked. Then pull it gently to make sure that it is locked.
2. AIRBAG CONTROL MODULE
Refer to the airbag system section. Airbag Connector > PROCEDURE">
3. BUCKLE SWITCH RH
Refer to the airbag system section. Airbag Connector > PROCEDURE">
Dtc c2223 transmitter 3 pressure data abnormal
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C2223 TRANSMITTER 3 PRESSURE DATA ABNORMALNOTE:Refer to DTC C2224 for diagnostic procedure. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C2224 TRANSMITTER 4 PRESSURE DAT ...
Preparation tool
AUTO HEADLIGHT BEAM LEVELER SYSTEM (DIAGNOSTICS) > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS — SUBARU SELECT MONITOR 4Used for setting of each function and troubleshooting for electrical system.NOTE:For detailed operation procedures of Subaru Se ...
Dtc b2271 ign relay control circuit
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2271 IGN RELAY CONTROL CIRCUITDTC detecting condition:• When malfunction is detected in IG1 and IG2 drive circuits in the keyless access CM.• When malfunction is de ...