Your vehicle's air conditioning system is equipped with an air filtration system.
Replace the air filter element according to the replacement schedule found in the "Warranty and Maintenance Booklet". This schedule should be followed to maintain the filter's dust collection ability. Under extremely dusty conditions, the filter should be replaced more frequently. Have your filter checked or replaced by your SUBARU dealer. For replacement, use only a genuine SUBARU air filter kit.
CAUTION
Contact your SUBARU dealer if the following occurs, even if it is not yet time to change the filter:
NOTE
The filter can influence the air conditioning, heating and defroster performance if not properly maintained.
Replacing an air filter
NOTE
We recommend that you take measures to protect the center console with masking tape first, so that you avoid scratching the center console with the glove box.
2. Remove the air filter according to the following procedure in order to prevent dust on the air cleaner from falling to the inside of its housing.
(1) Push in the four stoppers to unlock, and then slowly pull out the air filter 4 in (10 cm) from the housing.
(2) Completely pull out the air filter by gently tilting the front side of the air filter downward.
3. Replace the air filter element with a new one.
CAUTION
The arrow mark on the filter must point UP.
4. Reinstall the glove box, and connect the damper shaft.
5. Close the glove box.
Inspection
BODY CONTROL SYSTEM (DIAGNOSTICS) > General DescriptionINSPECTIONBefore performing diagnosis, check the following items which might affect body control system problems.1. Check the battery. Battery">2. Check the fuse condition.Make sure that ampere of the fuse is setting value, and it is ...
Removal
CLUTCH SYSTEM > Clutch PedalREMOVALCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">1. Turn the ignition switch to OFF.2. Disconnect the ground cable ...
Dtc b1690 door sensor rh failure
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1690 DOOR SENSOR RH FAILUREDIAGNOSIS START CONDITION:Ignition voltage is 10 V to 16 V.DTC DETECTING CONDITION:Front door impact sensor (RH) is faulty.If DTC B1690 is displayed, the circuit within the front door impact sensor (RH ...