Subaru Crosstrek Service Manual: Adjustment
WIPER AND WASHER SYSTEMS > Front Washer Nozzle and Hose
ADJUSTMENT
1. NOZZLE - WINDSHIELD WASHER
1. Turn the wiper switch to OFF position.
2. While the vehicle is at a standstill, insert a precision screwdriver (A) or equivalent wrapped with protective tape into the clearance on the upper/lower side or the right/left side of the nozzle - windshield washer to perform necessary adjustment.
CAUTION:
• The nozzle - windshield washer is made of resin. If precision screwdriver (A) or equivalent is inserted into discharge port for adjustment, the discharge port can be deformed, and washer fluid cannot be sprayed.
• Do not rotate the discharge port of the nozzle - windshield washer, otherwise it may be damaged.
3. Adjust the washer injection position as shown in the figure.
(A) | Nozzle - windshield washer | (B) | Ceramic line |
2. NOZZLE - WIPER ARM WASHER (MODEL WITH EyeSight)
CAUTION:
Check and adjust the spray position of the nozzle - wiper arm at the position where the wiper arm stops.
1. Turn the wiper switch to OFF position.
2. While the vehicle is stopped, check that the washer spray position is as shown in the figure.
3. After inspection, if the spray position is really out of the specified range, replace with a new arm assembly - windshield wiper assistor.
(A) | Wiping area of arm ASSY - windshield wiper assistor | (B) | Spray area |
Removal
WIPER AND WASHER SYSTEMS > Front Washer Nozzle and HoseREMOVAL1. NOZZLE - WINDSHIELD WASHER & HOSE1. Remove the arm assembly - windshield wiper. Front Wiper Arm > REMOVAL">2. Remove ...
Other materials:
Disassembly
CONTROL SYSTEMS > MT Gear Shift LeverDISASSEMBLY1. Remove the lock wires.(A)Lock wire2. Remove the rod from gear shift lever.(A)Rod(B)Lever(C)Stay3. Separate the rod and inner boot.4. Remove the snap ring from the stay.(A)Snap ring5. Separate the gear shift lever and the stay.6. Remove the boot a ...
Electrical component location Location
IMMOBILIZER (DIAGNOSTICS) > Electrical Component LocationLOCATION(1)Security indicator light (LED bulb)(3)Data link connector(5)Transponder(2)Body integrated unit(4)Antenna(6)Security control module (for C5 model only) ...
Inspection
MECHANICAL(H4DO) > Cylinder BlockINSPECTION1. CYLINDER BLOCK & PISTON1. Visually inspect to make sure that there are no cracks, scratches or other damage.2. Use liquid penetrant tester on the important sections to check for fissures.3. Check that there are no traces of gas leaking or water le ...
