MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Reverse Idler Gear
ADJUSTMENT
1. Select the appropriate reverse shifter lever from the table below, and adjust until the clearance between the reverse idler gear and transmission case wall is within specification.
Clearance A:
6.0 — 7.5 mm (0.236 — 0.295 in)
Reverse shifter lever | ||
Part No. | Mark | Contents |
32820AA070 | 7 | Far from case wall |
32820AA080 | 8 | Standard |
32820AA090 | 9 | Closer to case wall |
2. Select the appropriate adjusting washer from the table below, and adjust until the clearance between the reverse idler gear and transmission case wall is within specification.
Clearance:
0 — 0.5 mm (0 — 0.020 in)
Adjusting washer | |
Part No. | Thickness mm (in) |
803020151 | 0.4 (0.016) |
803020152 | 1.1 (0.043) |
803020153 | 1.5 (0.059) |
803020154 | 1.9 (0.075) |
803020155 | 2.3 (0.091) |
Relay and fuse
Inspection
Blind Spot Detection/Rear Cross Traffic Alert > Relay and FuseINSPECTION1. CHECK FUSE1. Remove the fuse and inspect visually.2. If the fuse is blown out, replace the fuse.NOTE:If the fuse is blown again, check the system wiring harness. Location
Blind Spot Detection/Rear Cross Traffi ...
Uniform tire quality grading standards
This information indicates the relative
performance of passenger car
tires in the area of treadwear,
traction, and temperature resistance.
This is to aid the consumer
in making an informed choice in the
purchase of tires.
Quality grades can be found where
applicable on the tire sidewall ...
Assembly
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Transfer Driven GearASSEMBLY1. Using the ST, install the taper roller bearing (transfer case side).CAUTION:Do not apply a load in excess of 10 kN (1 ton, 1.1 US ton, 1.0 Imp ton).NOTE:Be careful when handling, because the outer race and inner race of th ...