Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Adjustment

MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Reverse Check Sleeve

ADJUSTMENT

1. NEUTRAL POSITION ADJUSTMENT

1. Shift the gear into 3rd gear position.

2. Because of the return spring, until the arm contacts the stopper the shifter arm will feel lighter moving towards 1st/2nd gear and heavier towards the reverse gear.

3. Make adjustment so that the heavy stroke (reverse side) is a little heavier than the lighter stroke (1st/2nd side).

4. To adjust, remove the bolts holding the reverse check sleeve assembly to the case, and move the sleeve assembly outward, then place an adjustment shim between the sleeve assembly and the case to adjust the clearance.

CAUTION:

Be careful not to damage the O-ring when placing shims.

NOTE:

When the shim is removed, the neutral position will move closer to reverse; when the shim is added, the neutral position will move closer to 1st gear.

If it is not possible to adjust the clearance with only shims, replace the reverse accent shaft and re-adjust.

Adjusting shim

Part No.

Thickness mm (in)

32190AA000

0.15 (0.0059)

32190AA010

0.30 (0.0118)

Reverse accent shaft

Part No.

Mark

Remarks

32188AA130

S

Neutral position is closer to 1st gear.

32188AA140

T

Standard

32188AA150

U

Neutral position is closer to reverse gear.

2. REVERSE CHECK PLATE ADJUSTMENT

1. Shift the shifter arm to “5th” and then to reverse to see if the reverse check mechanism operates properly.

2. Also check to see if the arm returns to neutral when released from the reverse position. If the arm does not return properly, replace the reverse check plate.

Reverse check plate

Part No.

(A): No.

Angleθ

Content

32189AA001

0

28°

Arm stops closer to 5th gear.

32189AA011

1

31°

Arm stops closer to 5th gear.

32189AA021

2

34°

Arm stops in the center.

32189AA031

3

37°

Arm stops closer to reverse gear.

32189AA041

4

40°

Arm stops closer to reverse gear.

Reverse check sleeve
...

Removal
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Reverse Check SleeveREMOVAL1. Remove the manual transmission assembly from the vehicle. Manual Transmission Assembly > REMOVAL">2. Remove the ...

Other materials:

Adjustment
WIPER AND WASHER SYSTEMS > Rear Wiper ArmADJUSTMENT1. Operate the rear wiper once.2. Align the blade assembly - rear wipe with the marking on the glass.3. If the wiper blade is not aligned with the point mark, perform the removal of the rear wiper to align with the marking. Rear Wiper Arm > R ...

Towing with all wheels on the ground
1. Release the parking brake and put the transmission in the "N" position. 2. The ignition switch should be in the "ON" position while the vehicle is being towed. 3. Take up slack in the towline slowly to prevent damage to the vehicle. WARNING Never turn the ignition switch to t ...

Disassembly
SECURITY AND LOCKS > Ignition Key LockDISASSEMBLY1. Remove the immobilizer antenna assembly or the ignition switch illumination. Immobilizer Antenna > REMOVAL">2. Release the claws, and pull the key warning switch downwards to remove.3. Remove the screws and remove the key lock soleno ...

© 2016-2024 Copyright www.sucross.com