Subaru Crosstrek Service Manual: Adjustment

1. FOG LIGHT AIMING

1. Before checking the fog light assembly - front beam level, be sure of the following:

• The area around the fog light assembly - front has not sustained any scratches, damage or other type of deformation.

• The vehicle is parked on a level surface.

• The inflation pressure of tires is correct.

• The vehicle does not have load.

• Vehicle’s fuel tank is fully filled.

2. Bounce the vehicle several times to normalize the suspension.

3. Make certain that someone is seated in the driver’s seat.

4. Place the vehicle with the front end facing to the measurement panel.

5. Adjust the fog light assembly - front beam.

(1) Remove the screw and clips, and turn over the front side of the mud guard - front.

(2) Adjust the beam direction by turning the aiming screw from the bottom of the bumper face - front.

Front fog light assembly

Removal

Other materials:

General description
Caution Blind Spot Detection/Rear Cross Traffic Alert > General DescriptionCAUTION• Before disconnecting connectors of sensors or units, be sure to disconnect the ground cable from battery. When replacing the electrical parts provided with memory functions that store contents specified by ...

Interior light system Wiring diagram
WIRING SYSTEM > Interior Light SystemWIRING DIAGRAM1. WITHOUT EyeSight2. WITH EyeSight ...

Removal
POWER ASSISTED SYSTEM (POWER STEERING) > Steering ColumnREMOVALCAUTION:Before handling the airbag system components, always refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">1. Disconnect the ground cable ...