Subaru Crosstrek Service Manual: Adjustment
EXTERIOR BODY PANELS > Rear Gate
ADJUSTMENT
Adjust the clearance around the panel - rear gate as follows.
Part | Standard | |
A | Panel - rear gate to Roof panel | 6.0+1.0, −0.5 mm (0.24+0.04, −0.02 in) |
B | Surface level gap: Panel - rear gate to Roof panel | 1.0±1.0 mm (0.04±0.04 in) |
C | Panel - rear gate to Light assembly - rear combination | 6.0±1.0 mm (0.24±0.04 in) |
D | Surface level gap: Panel - rear gate to Light assembly - rear combination | 1.0±1.0 mm (0.04±0.04 in) |
E | Panel - rear gate to Bumper face - rear | 8.0±1.5 mm (0.31±0.06 in) |
1. Adjust the vertical and horizontal positions of the panel - rear gate.
(1) Loosen the mounting bolts of the hinge - rear gate.
(2) Adjust the vertical and horizontal clearance of the panel - rear gate.
Tightening torque:
25 N·m (2.55 kgf-m, 18.4 ft-lb)
2. Adjust the surface level gap between the panel - rear gate and the body.
(1) Remove the trim panel - rear skirt.
(2) Loosen the bolt.
(3) Tap the striker - rear gate using a plastic hammer to adjust the surface level gap between the panel - rear gate and the body.
Tightening torque:
25 N·m (2.55 kgf-m, 18.4 ft-lb)
Rear gate
...
Removal
EXTERIOR BODY PANELS > Rear GateREMOVALCAUTION:The panel - rear gate is heavy. When removing and installing it, always work in a team of two or more persons.1. REAR GATE PANEL1. Disconnect the grou ...
Other materials:
Cleaning aluminum wheels
Promptly wipe the aluminum wheels
clean of any kind of grime or agent. If dirt
is left on too long, it may be difficult to
clean off.
Do not use soap containing grit to
clean the wheels. Be sure to use a neutral
cleaning agent, and later rinse thoroughly
with water. Do not clean the ...
Specification
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > General DescriptionSPECIFICATIONFuel tankCapacity60 L (15.9 US gal, 13.2 Imp gal)LocationUnder rear seatFuel pumpTypeImpellerShutoff discharge pressure750 kPa (7.7 kg/cm2, 108.8 psi) or lessDischarge rate82 L (21.7 US gal, 18 Imp gal)/h or more[12.5 V at 343 ...
Disassembly
FRONT SUSPENSION > Front StrutDISASSEMBLY1. Using a coil spring compressor, compress the coil spring - front.2. Using a hexagon wrench to prevent strut rod from turning, remove the self-locking nut with ST.CAUTION:When installing the coil spring compressor to the coil spring, follow the operation ...
