EXTERIOR BODY PANELS > Rear Door
ADJUSTMENT
Adjust the clearance around the panel assembly - rear door as follows.
Part | Standard | |
A | Front door sash to Rear door sash | 5.5+1.5, −1.0 mm (0.22+0.06, −0.04 in) |
B | Panel assembly - front door to Panel assembly - rear door | 4.5±1.0 mm (0.18±0.04 in) |
C | Roof panel to Rear door sash | 5.1+1.5, −1.0 mm (0.20+0.06, −0.04 in) |
D | Surface level gap between roof panel and rear door sash | 6.6±1.5 mm (0.26±0.06 in) |
E | Panel assembly - rear door to Rear quarter panel | 4.1±1.0 mm (0.16±0.04 in) |
F | Panel assembly - rear door to Side sill | 6.0±1.5 mm (0.24±0.06 in) |
1. Adjust the vertical and horizontal positions of the panel assembly - rear door.
(1) Loosen the body side bolts of the upper hinge - rear door and the lower hinge - rear door.
(2) Adjust the vertical and horizontal clearance of the panel assembly - rear door.
2. Adjust the surface level gap between the panel assembly - rear door and the body.
CAUTION:
Do not use an impact wrench. Welding area on the striker nut plate is easily broken.
(1) Loosen the screws (A).
(2) Tap the striker - rear door (B) using a plastic hammer to adjust the surface level gap between the rear end of the panel assembly - rear door and the rear quarter.
Inspection
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Engine Oil Temperature SensorINSPECTION1. Check that the engine oil temperature sensor has no deformation, cracks or other damages.2. Immerse the engine oil temperature sensor and a thermometer in water.CAUTION:Take care not to allow water to get into the eng ...
Access key
Access key (main)
Access key (sub)
Key number plate
The vehicle has two access keys and a
key number plate. For details about the
key number plate, refer to "Key number
plate" 2-3.
A mechanical key is attached to each
access key. The mechanical key is used
for the following opera ...
Assembly
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Extension CaseASSEMBLY1. Press-fit the dust cover into extension case.2. Install the extension case oil seal to extension case. Differential Side Retainer Oil Seal > REPLACEMENT">3. Install all plugs.NOTE:• Use a new O-ring or a gasket ...