EXTERIOR BODY PANELS > Front Hood
ADJUSTMENT
Adjust the clearance around the hood COMPL - front as follows.
Part | Standard | |
A | Hood COMPL - front to Front grille | 7.5±1.0 mm (0.30±0.04 in) |
B | Hood COMPL - front to Bumper face - front | 6.0+2.0, −1.0 mm (0.24+0.08, −0.04 in) |
C | Offset value: Hood COMPL - front to Front end of fender COMPL - front | 0+0.5, −1.0 mm (0+0.02, −0.04 in) |
D | Hood COMPL - front to Fender COMPL - front (from front end to just before curved portion) | 3.5±1.0 mm (0.14±0.04 in) |
E | Hood COMPL - front to Fender COMPL - front (from rear end to just before curved portion) | 4.5±1.0 mm (0.18±0.04 in) |
F | Surface level gap: Hood COMPL - front to Fender COMPL - front | 0.5+0.5, −1.0 mm (0.02+0.02, −0.04 in) |
1. Adjust the horizontal position of the hood COMPL - front.
(1) Loosen the attaching nuts of the hinge COMPL - front hood on the left and right sides.
(2) Adjust the horizontal clearance of the hood COMPL - front, and tighten the attaching nuts of the hinge COMPL - front hood.
Tightening torque:
25 N·m (2.55 kgf-m, 18.4 ft-lb)
2. Adjust the front end height of the hood COMPL - front.
(1) Loosen the bolts on the lock assembly - front hood.
(2) Adjust the lock assembly - front hood by moving it up and down.
Tightening torque:
33 N·m (3.36 kgf-m, 24.3 ft-lb)
3. Rotate the buffer - front hood of the hood COMPL - front to adjust the height.
Dtc p0962 pressure control solenoid "a" control circuit low
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0962 PRESSURE CONTROL SOLENOID "A" CONTROL CIRCUIT LOWDTC detecting condition:Immediately at fault recognitionTrouble symptom:• Engine speed increases abruptly, and can n ...
Installation
SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF) > Glass LidINSTALLATION1. GLASS LID1. Using a new TORX® bolt, install the lid assembly - sunroof.Tightening torque:4.5 N·m (0.46 kgf-m, 3.3 ft-lb)2. Perform the open/close operation checks for the glass lid.3. Check the height of the lid assembly - ...
Dtc p0353 ignition coil "c" primary control circuit/open
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0353 IGNITION COIL "C" PRIMARY CONTROL CIRCUIT/OPENNOTE:For the diagnostic procedure, refer to DTC P0351. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0351 IGNITION COIL " ...