EXTERIOR BODY PANELS > Front Door
ADJUSTMENT
Adjust the clearance around the panel assembly - front door as follows.
Part | Standard | |
A | Fender COMPL - front to Panel assembly - front door | 4.5±1.0 mm (0.18±0.04 in) |
B | Panel assembly - front door to Side sill | 6.0+1.5, −1.0 mm (0.24+0.06, −0.04 in) |
C | Roof panel to Front door sash | 5.1+1.5, −1.0 mm (0.20+0.06, −0.04 in) |
D | Surface level gap between roof panel and front door sash | 7±1.5 mm (0.28±0.06 in) |
E | Front door sash to Rear door sash | 5.5+1.5, −1.0 mm (0.22+0.06, −0.04 in) |
F | Panel assembly - front door to Panel assembly - rear door | 4.5±1.0 mm (0.18±0.04 in) |
1. Adjust the vertical and horizontal positions of the panel assembly - front door.
Preparation tool:
ST: WRENCH (925610000)
(1) Using ST, loosen the body side bolts of the upper hinge - front door and the lower hinge - front door.
(2) Adjust the vertical and horizontal clearance of the panel assembly - front door.
2. Adjust the surface level gap between the panel assembly - front door and the panel assembly - rear door.
CAUTION:
Do not use an impact wrench. Welding area on the striker nut plate is easily broken.
(1) Loosen the screws (A).
(2) Tap the striker - front door (B) using a plastic hammer to adjust the surface level gap between the rear end of the panel assembly - front door and the front end of the panel assembly - rear door.
Operation
AUTO HEADLIGHT BEAM LEVELER SYSTEM (DIAGNOSTICS) > Subaru Select MonitorOPERATION• For detailed operation procedures, refer to “Application help”.• If the auto headlight beam leveler CM can not communicate with Subaru Select Monitor, perform “COMMUNICATION FOR INITIA ...
Diagnostic procedure with phenomenon
HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > Diagnostics with PhenomenonDIAGNOSTIC PROCEDURE WITH PHENOMENON1. NOTHING IS DISPLAYED ON THE SCREEN. NO ILLUMINATION APPEARS ON THE INDICATORTrouble symptom:• When the AUTO button is pressed with IGN ON, nothing is displayed on the screen or indicator ...
Dtc p1499 coil 4 egr "a" control circuit high
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P1499 COIL 4 EGR "A" CONTROL CIRCUIT HIGHDTC detecting condition:Immediately at fault recognitionTrouble symptom:• Improper idling• Poor driving performance• Engine breathingCAUTION ...