CONTROL SYSTEMS > Select Cable
ADJUSTMENT
1. Shift the select lever to “N” range.
2. Lift up the vehicle.
3. Remove the center exhaust pipe. Center Exhaust Pipe > REMOVAL">
4. Remove the center exhaust cover.
5. Loosen the adjusting nuts on both sides.
(A) | Adjusting nut A |
(B) | Adjusting nut B |
6. Turn adjusting nut B until it lightly touches the connector.
(A) | Forward side |
(B) | Select lever |
(C) | Connector |
(D) | Adjusting nut B |
(E) | Contact point |
(F) | Adjusting nut A |
7. Set a spanner wrench to adjusting nut B so that it does not rotate, and then tighten the adjusting nut A.
Tightening torque:
7.5 N·m (0.8 kgf-m, 5.5 ft-lb)
(A) | Adjusting nut A |
(B) | Adjusting nut B |
8. After the completion of adjustment, confirm that the select lever operates normally at all ranges.
9. Install in the reverse order of removal.
Control screen and audio panel
Select to display the audio source
selection screen.
Select to display the play mode
currently selected. Refer to "Select
play mode"
Select to display folder list.
Shows progress.
The tracks in the folder are played
back 10 seconds each from the
beginning of the track.
Sel ...
Adjustment
AIRBAG SYSTEM > Roll ConnectorADJUSTMENTCAUTION:• Do not rotate the roll connector to more than the specified number of turns. Otherwise, the roll connector internal wire may be broken.• When determining the end stop, rotate the connector slowly without applying excessive force. Apply ...
Dtc b19f0 short in front p/t 2 rh
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B19F0 SHORT IN FRONT P/T 2 RHDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Lap seat belt pretensioner (RH) circuit is shorted.• Lap seat belt pretensioner (RH) is faulty.• ...