Subaru Crosstrek Service Manual: Adjustment
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transfer Driven Gear
ADJUSTMENT
NOTE:
When the transfer driven gear or bearing is replaced, select the transfer driven gear shim. Transfer Clutch > ADJUSTMENT">
Removal
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transfer Driven GearREMOVAL1. Remove the transmission assembly from the vehicle. Automatic Transmission Assembly > REMOVAL">2. Remove the ext ...
Other materials:
Most common causes of corrosion
The most common causes of corrosion
are:
The accumulation of moisture retaining
dirt and debris in body panel sections,
cavities, and other areas.
Damage to paint and other protective
coatings caused by gravel and stone
chips or minor accidents.
Corrosion is accelerated on the vehic ...
Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Mode Door ActuatorINSPECTION1. CHECK LINK1. Visually check the operation range of the link, and remove the foreign material if any.2. Operate the air flow control dial or switch to check that the link operates normally.3. If it does not operate normally ...
Dtc p0506 idle control system rpm - lower than expected
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0506 IDLE CONTROL SYSTEM RPM - LOWER THAN EXPECTEDDTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.TROUBLE SYMPTOM:• Hard to start the engine.• Engine does not ...
