CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transfer Clutch
ADJUSTMENT
1. Install the transfer clutch assembly to the extension case with the transfer driven gear shims and thrust bearings removed.
2. Install the thrust bearing to the transfer driven gear.
NOTE:
Make sure to install in the right direction.
3. Using the ST, measure the height “A” from the ST end face to the thrust bearing catch surface of the transfer clutch assembly.
ST 499575500 | GAUGE |
4. Using the ST, measure the height “B” from the transmission case mating surface to the end of ST.
ST 499575500 | GAUGE |
5. Obtain the thickness of transfer driven gear shim using the following formula to select one to three transfer driven gear shims.
T (mm) = A − B − (0.05 — 0.25)
[T (in) = A − B − (0.002 — 0.01)]
T: Transfer driven gear shim thickness
A: Height from the ST end face to the transfer clutch assembly thrust bearing catch surface
B: Height from the mating surface of the transmission case to the end of the ST
0.05 — 0.25 mm (0.002 — 0.01 in): Clearance
Transfer driven gear shim | |
Part No. | Thickness mm (in) |
33280AA030 | 0.3 (0.012) |
33280AA040 | 0.4 (0.016) |
33280AA050 | 0.5 (0.020) |
Power window operation by passengers
Passenger's side power window switches
Each passenger window can be controlled
by the power window switch located on
the door.
Operating the windows
To open:
Press the switch down and hold it until the
window reaches the desired position.
To close:
Pull the switch up and hold it u ...
Inspection
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Fuel Level SensorINSPECTION1. Check that the fuel level sensor has no damage.2. Measure the fuel level sensor float position.NOTE:When inspecting the fuel level sensor, perform the work with the sensor installed to the fuel pump.(1)FULL(2)EMPTY(3)Fuel tank se ...
Removal
LIGHTING SYSTEM > Rear Height SensorREMOVALCAUTION:Always remove the sensor assembly - headlight beam leveler before removing any parts related to the suspension.1. Disconnect the ground cable from battery. NOTE">2. Lift up the vehicle, and remove the left rear wheel.3. Remove the sensor ...