CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Differential Gear Oil
ADJUSTMENT
NOTE:
Immediately after removing the overflow drain plug, remaining gear oil (approx. 8 cc) may come out of the overflow pipe. This is not included in the specified amount. When removing the overflow drain plug, make sure the gear oil flows out of the overflow drain plug hole by filling with gear oil.
1. Turn the ignition switch to OFF.
2. Lift up the vehicle.
3. Remove the filler plug.
(A) | Filler plug |
4. Remove the overflow drain plug.
(A) | Overflow drain plug |
5. Fill in the differential gear oil through the filler plug hole up to where the oil flows out of the overflow drain plug.
Recommended gear oil:
General Description > SPECIFICATION">
6. When the flow of the differential gear oil turns into a narrow stream, install the overflow drain plug.
NOTE:
Use a new gasket.
Tightening torque:
50 N·m (5.1 kgf-m, 36.9 ft-lb)
7. Install the filler plug.
NOTE:
Use a new gasket.
Tightening torque:
50 N·m (5.1 kgf-m, 36.9 ft-lb)
Warning and indicator lights
Mark
Name
Seatbelt warning light
Front passenger's
seatbelt warning light
SRS airbag system
warning light
Front passenger's
frontal airbag ON indicator
Front passenger's
frontal airbag OFF indi ...
Removal
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Reverse Brake AssemblyREMOVAL1. Remove the transmission assembly from the vehicle. Automatic Transmission Assembly > REMOVAL">2. Remove the air breather hose. Air Breather Hose > REMOVAL">3. Remove the control valve body. Contro ...
Dtc p0141 o2 sensor heater circuit bank 1 sensor 2
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0141 O2 SENSOR HEATER CIRCUIT BANK 1 SENSOR 2Refer to DTC P0037 for diagnostic procedure. Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC P0037 A/F / O2 HEATER CONTROL CIRCUIT LOW BANK 1 SEN ...