Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Adjustment

CLUTCH SYSTEM > Clutch Switch

ADJUSTMENT

1. Loosen the lock nut of the clutch start switch.

(A)

Lock nut

(B)

Clutch start switch

2. Disconnect the harness connector of the clutch start switch.

3. Remove the snap pin and clevis pin connecting the clutch pedal and operating rod.

(A)

Clevis pin

(B)

Snap pin

(C)

Push rod

(D)

Lock nut

4. Adjust the clutch start switch so that the switch turns on when the clearance between clutch pedal stopper and clutch pedal is within the specification described below, and then tighten the lock nut.

Clearance A:

6.3 — 8.6 mm (0.25 — 0.34 in)

Tightening torque:

8 N·m (0.8 kgf-m, 5.9 ft-lb)

NOTE:

Using a plate of the same thickness for the clearance facilitates the adjustment operation.

Using the Subaru Select Monitor or a tester, check the position where the switch turns on.

Check the following figure for the terminal layout of the harness connector.

When performing adjustment by the clearance between clutch start switch and clutch pedal plate, perform installation according to the following gap.

Clearance B:

8.6 — 9.0 mm (0.34 — 0.35 in)

5. Connect the clutch start switch connector.

Clutch switch
...

Removal
CLUTCH SYSTEM > Clutch SwitchREMOVALCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. Genera ...

Other materials:

Installation
LUBRICATION(H4DO) > Engine Oil FilterINSTALLATION1. OIL FILTERCAUTION:Do not tighten excessively, or oil may leak.1. Clean the oil filter installation surface.2. Obtain a new oil filter and apply a thin coat of engine oil to the seal rubber.3. Install the oil filter by turning it by hand, being c ...

Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Front Oxygen (A/F) SensorREMOVAL1. Disconnect the ground cable from battery.2. Remove the radiator sub fan and fan motor assembly. Radiator Sub Fan and Fan Motor > REMOVAL">3. Lift up the vehicle.4. Remove the under cover. Front Under Cover > ...

Dtc b14e9 intake door actuator circuit open
HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B14E9 INTAKE DOOR ACTUATOR CIRCUIT OPENDTC detecting condition:Intake door actuator potentiometer circuit is open.Trouble symptom:FRESH/RECIRC does not operate.Wiring diagram:Air conditioning system ...

© 2016-2024 Copyright www.sucross.com