CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Active Test
OPERATION
CAUTION:
• Be sure to perform the active test while the engine is not running.
• After executing the active test, execute the Clear Memory Mode.
1. On «Start» display, select «Diagnosis».
2. On «Vehicle selection» display, input the vehicle information and select «Confirmed».
3. On «Main Menu» display, select «Each System».
4. On «Select System» display, select «Transmission Control System».
5. On «Select Function» display, select «Active Test».
Item | SSM display | Execution condition |
Activating the actuator ON/OFF | F&R Clutch Solenoid | When all of the following conditions are met: |
• P range
• Ignition switch is ON (engine stops)
• Battery voltage is 10.9 V or more
Secondary Solenoid
Primary Down Solenoid
Primary Up Solenoid
AWD Solenoid
Lock-Up Duty Solenoid
NOTE:
For detailed operation procedures, refer to “Application help”.
Canceling the function for meter/gauge needle movement upon turning on the
ignition switch
It is possible to activate or deactivate the
movement of the meter needles and
gauge needles that takes place when the
ignition switch is turned to the "ON"
position.
Type A combination meter
To change the setting, perform the following
procedure.
1. Turn the ignition switch to the "LOCK"/ ...
Dtc b2a10 battery voltage high
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2A10 BATTERY VOLTAGE HIGHDiagnosis start condition:When ignition switch is ON.DTC detecting condition:DCM battery power supply input of 16 V or more continues for 5 seconds.Trouble symptom:RED LED illumi ...
Installation
EXTERIOR/INTERIOR TRIM > Cowl PanelINSTALLATIONCAUTION:Before installing the windshield glass and cowl panel, make sure there are no gravel in the installing area.1. Install the cowl panel assembly.CAUTION:If the cowl panel assembly cannot be installed properly, do not hit or set it forcibly. The ...