Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Activation of malfunction indicator light

ENGINE (DIAGNOSTICS)(H4DO) > Malfunction Indicator Light

ACTIVATION OF MALFUNCTION INDICATOR LIGHT

1. When the ignition switch is turned to ON (engine OFF), the malfunction indicator light (A) in the combination meter illuminates.

NOTE:

If the malfunction indicator light does not illuminate, perform diagnostics of the malfunction indicator light circuit or the combination meter circuit. Malfunction Indicator Light > MALFUNCTION INDICATOR LIGHT DOES NOT COME ON">

2. After starting the engine, the malfunction indicator light goes out. If it does not go off, any of the engine and emission control system has malfunction.

(1)

No faulty

(2)

Trouble occurs

(3)

ON

(4)

OFF

(5)

Ignition switch ON

(6)

Engine start

3. If the diagnostic system detects a misfire which could damage the catalyst, the malfunction indicator light will blink at a cycle of 1 Hz.

(1)

ON

(2)

OFF

(3)

Ignition switch ON

(4)

Engine start

(5)

Misfire start

(6)

1 second

4. Install the delivery (test) mode fuse (A) with ignition switch to OFF.

CAUTION:

Do not use any fuses that are installed on the vehicle.

(1) When the ignition switch is turned to ON (engine OFF), the malfunction indicator light illuminates.

(2) After the engine starts, malfunction indicator light blinks in a cycle of 0.5 Hz. (During diagnosis)

(3) Malfunction indicator light blinks at a cycle of 3 Hz after diagnosis if there is no trouble. Malfunction indicator light illuminates if faulty.

(1)

ON

(2)

OFF

(3)

Ignition switch ON

(4)

1 second

Malfunction indicator light remains blinking
ENGINE (DIAGNOSTICS)(H4DO) > Malfunction Indicator LightMALFUNCTION INDICATOR LIGHT REMAINS BLINKINGDiagnosis:The delivery (test) mode fuse circuit is short-circuited to ground.Trouble symptom:Malf ...

Malfunction indicator light does not come on
ENGINE (DIAGNOSTICS)(H4DO) > Malfunction Indicator LightMALFUNCTION INDICATOR LIGHT DOES NOT COME ONTROUBLE SYMPTOM:When the ignition switch is turned to ON (engine OFF), malfunction indicator ligh ...

Other materials:

Seat fabric
Remove loose dirt, dust or debris with a vacuum cleaner. If the dirt is caked on the fabric or hard to remove with a vacuum cleaner, use a soft brush then vacuum it. Wipe the fabric surface with a tightly wrung cloth and dry the seat fabric thoroughly. If the fabric is still dirty, wipe usi ...

Removal
EXTERIOR/INTERIOR TRIM > Roof TrimREMOVAL1. CROSSTREK MODELCAUTION:• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">• Airbag system satellite s ...

Caution
ENGINE (DIAGNOSTICS)(H4DO) > General DescriptionCAUTION1. Airbag system wiring harness is routed near the ECM, main relay and fuel pump relay.CAUTION:• Do not use electrical test equipment on the airbag system circuits.• Be careful not to damage the airbag system wiring harness when s ...

© 2016-2024 Copyright www.sucross.com