To change the setting of your vehicle's alarm system for activation or deactivation, do the following.
1. Disarm the alarm system. Refer to "Disarming the system" 2-30.
2. Sit in the driver's seat and shut all doors and the rear gate.
3. Turn the ignition switch to the "ON" position.
4. Hold down the REAR (UNLOCK) side of the driver's power door locking switch, open the driver's door within the following 1 second, and wait 10 seconds without releasing the switch. The setting will then be changed as follows.
If the system was previously activated: The odometer/trip meter screen displays as follows and the horn sounds twice, indicating that the system is now deactivated.
If the system was previously deactivated: The odometer/trip meter screen displays as follows and the horn sounds once, indicating that the system is now activated.
NOTE
You may have the above setting change done by your SUBARU dealer.
Phone settings
You can transfer the phonebook information
and adjust the volume of your phone
using the Bluetooth phone system.
NOTE
The ringer volume for outgoing and
incoming calls, as well as the volume
while on hold or during a call are
controlled independently from the volume
of the audio sourc ...
Dtc u0151 lost communication with restraints control module
LAN SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0151 LOST COMMUNICATION WITH RESTRAINTS CONTROL MODULEDTC DETECTING CONDITION:No data is received from airbag CM.TROUBLE SYMPTOM:Cooperation control with airbag CM does not operate properly.STEPCHECKYESNO1.CHEC ...
Removal
ENTERTAINMENT > AudioREMOVALCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">1. Disconnect the ground cable from battery and wait for at least 60 sec ...