Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: ABS warning light

CAUTION

If any of the following conditions occur, we recommend that you have the ABS repaired at the first available opportunity by your SUBARU dealer.

When the warning light is on (and the brake system warning light is off), the ABS function shuts down. However, the conventional brake system continues to operate normally.

The ABS warning light illuminates together with the brake system warning light if the EBD system malfunctions. For further details of the EBD system malfunction warning, refer to "Electronic Brake Force Distribution (EBD) system warning"

NOTE

If the warning light behavior is as described in the following conditions, the ABS may be considered normal.

When driving with an insufficient battery voltage such as when the engine is jump started, the ABS warning light may illuminate.

This is due to the low battery voltage and does not indicate a malfunction.

When the battery becomes fully charged, the light will turn off.

Low tire pressure warning light (U.S.-spec. models)
When the ignition switch is turned to the "ON" position, the low tire pressure warning light will illuminate for approximately 2 seconds to check that the tire pressure monitoring system (TPMS ...

Brake system warning light (red)
The light illuminates with the parking brake applied while the ignition switch is in the "ON" position. It turns off when the parking brake is fully released. WARNING Driving with the brak ...

Other materials:

Installation
STARTING/CHARGING SYSTEMS(H4DO) > Battery Current & Temperature SensorINSTALLATION1. BATTERY CURRENT SENSORInstall in the reverse order of removal.Tightening torque: General Description > COMPONENT">3 N·m (0.3 kgf-m, 2.2 ft-lb)2. BATTERY TEMPERATURE SENSORInstall in the reve ...

Diagnostic procedure with phenomenon
HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > Diagnostics with PhenomenonDIAGNOSTIC PROCEDURE WITH PHENOMENON1. NOTHING IS DISPLAYED ON THE SCREEN. NO ILLUMINATION APPEARS ON THE INDICATORTrouble symptom:• When the AUTO button is pressed with IGN ON, nothing is displayed on the screen or indicator ...

Operation
SECURITY AND LOCKS > Impact SensorOPERATION1. IMPACT SENSOR SETTING USING SUBARU SELECT MONITOR1. Make an impact sensor setting.(1) Connect the Subaru Select Monitor.NOTE:For detailed operation procedures, refer to “Application help”.(2) Turn the ignition switch to ON.(3) On «Start» ...

© 2016-2025 Copyright www.sucross.com