Subaru Crosstrek Service Manual: 61
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Cancel Code
61
Malfunction in the stop light & brake switch is detected.
TROUBLE SYMPTOM:
• Cruise control cannot be set.
• Cruise control cannot be released.
Refer to DTC 12 for diagnostic procedure.
Diagnostic Procedure with Cancel Code > 12">
45
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Cancel Code45Malfunction of the combination meter is detected.Combination meter malfunction is detected during cruise driving or crui ...
62
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Cancel Code62Neutral position switch malfunction is detected.TROUBLE SYMPTOM:Cruise control cannot be set.Refer to DTC 14 for diagnos ...
Other materials:
Removal
DRIVE SHAFT SYSTEM > Rear Drive ShaftREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Lift up the vehicle, and then remove the rear wheels.3. Remove the axle nut.CAUTION:Do not loosen the axle nut while the rear axle is loaded. Doing so may damage the hub unit bearing.(1) Lif ...
Read cancel code Operation
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Read Cancel CodeOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».3. On «Main Menu» display, select «Each System».4. On «Select System» display, sele ...
Two separate circuits
Your vehicle has two separate circuit
brake systems. Each circuit works diagonally
across the vehicle. If one circuit of
the brake system should fail, the other half
of the system still works. If one circuit fails,
the brake pedal will go down much closer
to the floor than usual and you will n ...
