Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: 32

CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Cancel Code

32

This DTC is detected out of vehicle speed range.

Increase vehicle speed high enough to allow the cruise control to function, and then perform setting operation again.

If cancel code is still detected after setting cruise again, perform the diagnosis for DTC 22.

Refer to DTC 22 for diagnostic procedure.

Diagnostic Procedure with Cancel Code > 22">

31
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Cancel Code31Engine speed signal malfunction is detected.Abnormal increase of engine speed is detected.Gear is placed in 1st or Rever ...

34
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Cancel Code34The vehicle has been driven at a speed higher than set speed for a long time (approximately 10 minutes) during cruise dr ...

Other materials:

Initial illumination for system check
When the ignition switch of the Subaru Ascent is turned to the "ON" position, multiple warning and indicator lights illuminate briefly and then turn off. This built-in self-check confirms that the systems and indicator bulbs are functioning correctly. To perform this system check, a ...

Shift lock function
The shift lock function helps prevent the improper operation of the select lever. The select lever cannot be operated unless the ignition switch is turned to the "ON" position and the brake pedal is depressed. The select lever cannot be moved from the "P" position to any other positio ...

Electrical specification
OCCUPANT DETECTION SYSTEM (DIAGNOSTICS) > Control Module I/O SignalELECTRICAL SPECIFICATIONCAUTION:Never remove the occupant detection control module, occupant detection sensor or seat frame because they are integrated into one unit.Terminal No.Terminal nameInput/Output valueNote1Airbag CM commun ...

© 2016-2026 Copyright www.sucross.com