Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: 22

CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Cancel Code

22

Malfunction related to vehicle speed sensor is detected.

DIAGNOSIS:

Open or shorted circuit in vehicle speed sensor system.

TROUBLE SYMPTOM:

Cruise control cannot be set. (Cancelled immediately.)

STEPCHECKYESNO

1.CHECK ABS OR VDC WARNING LIGHT.

1) Turn the ignition switch to ON.

2) After the initial operation of combination meter is completed, check if ABS or VDC warning light continues to illuminate.

Does the warning light continue to illuminate?

Check the VDCCM.
Basic Diagnostic Procedure">

Diagnostic Procedure with Cancel Code > 22">Go to Step 2.

2.CHECK DTC OF LAN COMMUNICATION CIRCUIT.

Read the DTC of body integrated unit using Subaru Select Monitor. Read Diagnostic Trouble Code (DTC)">

Is DTC displayed?

Perform inspection according to DTC.

Replace the ECM.
Engine Control Module (ECM)">

21
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Cancel Code21Cruise control command switch malfunction is detected.TROUBLE SYMPTOM:• Cruise control cannot be set. (Cancelled i ...

24
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Cancel Code24Malfunction in cruise control-related switch is detected.TROUBLE SYMPTOM:• Cruise control cannot be set. (Cancelle ...

Other materials:

Rear wiper
To turn the rear wiper on, turn the knob switch upward. To turn the wiper off, return the knob switch to the " " position. With the switch turned to the "  " position, the rear wiper will operate intermittently at intervals corresponding to the vehicle speed. In this position, whe ...

Repair
EXTERIOR/INTERIOR TRIM > Front BumperREPAIR1. COATING METHOD FOR PP BUMPERProcess No.Process nameJob contents1Bumper installationPlace the bumper on a paint worktable as required. Use the paint worktable conforming to inner shape of bumper if possible.Cross section of bumper(1) Bumper(2) Paint wo ...

Preparation for overhaul Procedure
MECHANICAL(H4DO) > Preparation for OverhaulPROCEDURE1. After removing the engine from the vehicle body, attach the ST to the engine as shown in the figure.NOTE:When using a commercially sold engine stand, follow the instructions of engine stand used.Tightening torque:35 N·m (3.6 kgf-m, 25. ...

© 2016-2026 Copyright www.sucross.com