Subaru Crosstrek Service Manual: 16

Detected when ignition switch is turned to OFF or malfunction related to the ignition switch occurs.

TROUBLE SYMPTOM:

Cruise control cannot be set.

WIRING DIAGRAM:

Cruise control system Cruise Control System > WIRING DIAGRAM">

1.CHECK IGNITION SWITCH CIRCUIT.

1) Turn the ignition switch to OFF.

2) Disconnect the ECM harness connector.

3) Turn the ignition switch to ON.

4) Measure the voltage between harness connector terminal and chassis ground.

Connector & terminal

(B137) No. 27 (+) — Chassis ground (−):

Is the voltage 10 V or more?

Check for poor contact of ECM connector.

• Check fuse No. 12 (in fuse & relay box).

• Check the harness for open or short circuit between ignition switch and ECM.

15

21

Other materials:

Dtc b2a07 backup battery charge system performance
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2A07 BACKUP BATTERY CHARGE SYSTEM PERFORMANCEDIAGNOSIS START CONDITION:When ignition switch is ON.DTC DETECTING CONDITION:Backup battery is disconnected for at least 5 seconds when the ignition switch is ...

Installation
BRAKE > Master CylinderINSTALLATION1. Replace the seal sub assembly for the master cylinder assembly with a new part.CAUTION:Be careful not to install the seal sub assembly in the wrong location.(a)Primary piston(b)Seal sub ASSY(c)Install the seal sub assembly to this surface.2. Install each part ...

Using a flat-bed truck
This is the best way to transport your vehicle. Use the following procedures to ensure safe transportation. 1. Shift the select lever into the "P" position for CVT models. Shift the shift lever into the "1st" position for MT models. 2. Pull up the parking brake lever firmly. 3. Secur ...