Subaru Crosstrek Service Manual: Replacement

CAUTION:

• Directly after the vehicle has been running or the engine has been idling for a long time, the CVTF is hot. Be careful not to burn yourself.

• Be careful not to spill the CVTF on exhaust pipe to prevent it from emitting smoke or causing fires. If CVTF adheres, wipe it off completely.

• Always use specified CVTF. Using other fluid will cause malfunction.

1. Lift up the vehicle, and remove the CVTF drain plug.

2. Check the CVTF condition. CVTF > CONDITION CHECK">

3. Install the CVTF drain plug and gasket.

NOTE:

• Use a new gasket.

Tightening torque:

31 N·m (3.2 kgf-m, 22.9 ft-lb)

4. Remove the filler plug.

5. Add the specified fluid up to the filler plug hole lower section.

Specified fluid:

General Description > SPECIFICATION">

6. Temporarily tighten the filler plug.

7. Idle the engine to raise CVTF temperature to 35 — 45°C (95 — 113°F) on Subaru Select Monitor.

8. Operate the select lever in P > R > N > D and D > N > R > P to circulate CVTF with the engine idling.

CAUTION:

Pay special attention to the following operations as the engine is at idle.

9. With the select lever shifted to “P” range and the engine started, lift up the vehicle. Adjust the CVTF level and check for leakage. CVTF > ADJUSTMENT">

10. Replace with a new gasket, and attach the filler plug.

Tightening torque:

50 N·m (5.1 kgf-m, 36.9 ft-lb)

Inspection

Cvtf cooler (with warmer function)

Other materials:

Illumination brightness control
The illumination brightness of the instrument panel dims under the following conditions. when the light switch is in the " " or "  " position You can also adjust the illumination brightness for better visibility in the following ways. To brighten, turn the control dial upward. ...

Dtc u0151 lost communication with restraints control module
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0151 LOST COMMUNICATION WITH RESTRAINTS CONTROL MODULEDetected when CAN data is not received from airbag CM.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROCEDURE"> ...

Dtc c1221 front left abs sensor circuit
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1221 FRONT LEFT ABS SENSOR CIRCUITNOTE:For the diagnostic procedure, refer to “DTC C1241 REAR LEFT ABS SENSOR CIRCUIT”. Diagnostic Procedure with Diagnostic Trouble Code (DTC) & ...