Subaru Crosstrek Service Manual: Replacement

CAUTION:

• Directly after the vehicle has been running or the engine has been idling for a long time, the CVTF is hot. Be careful not to burn yourself.

• Be careful not to spill the CVTF on exhaust pipe to prevent it from emitting smoke or causing fires. If CVTF adheres, wipe it off completely.

• Always use specified CVTF. Using other fluid will cause malfunction.

1. Lift up the vehicle, and remove the CVTF drain plug.

2. Check the CVTF condition. CVTF > CONDITION CHECK">

3. Install the CVTF drain plug and gasket.

NOTE:

• Use a new gasket.

Tightening torque:

31 N·m (3.2 kgf-m, 22.9 ft-lb)

4. Remove the filler plug.

5. Add the specified fluid up to the filler plug hole lower section.

Specified fluid:

General Description > SPECIFICATION">

6. Temporarily tighten the filler plug.

7. Idle the engine to raise CVTF temperature to 35 — 45°C (95 — 113°F) on Subaru Select Monitor.

8. Operate the select lever in P > R > N > D and D > N > R > P to circulate CVTF with the engine idling.

CAUTION:

Pay special attention to the following operations as the engine is at idle.

9. With the select lever shifted to “P” range and the engine started, lift up the vehicle. Adjust the CVTF level and check for leakage. CVTF > ADJUSTMENT">

10. Replace with a new gasket, and attach the filler plug.

Tightening torque:

50 N·m (5.1 kgf-m, 36.9 ft-lb)

Inspection

Cvtf cooler (with warmer function)

Other materials:

Dtc p0719 brake switch "b" circuit low
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0719 BRAKE SWITCH "B" CIRCUIT LOWDTC detecting condition:Immediately at fault recognitionTrouble symptom:Gear is not shifted down when climbing a hill or driving down a hill.CA ...

Electrical component location Location
HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > Electrical Component LocationLOCATION1. OUTSIDE VEHICLE(1)A/C compressor(3)Pressure switch(4)Ambient sensor(2)A/C relay 2. COMPARTMENT(1)Air mix door actuator LH*2(5)Intake door actuator(9)A/C control panel(2)In-vehicle sensor(6)Mode door actuator(10)Blow ...

Deleting the contact data
You can delete the phonebook data stored in the audio set. 1. Display the "PHONE" screen. Refer to "How to change the hands-free phone system" F5-73. 2. Touch the "Contacts" key, and then select the "Delete All" key. 3. Select the "OK" key when the confirmation screen appears. compati ...