Subaru Crosstrek Service Manual: Replacement

CAUTION:

• Directly after the vehicle has been running or the engine has been idling for a long time, the CVTF is hot. Be careful not to burn yourself.

• Be careful not to spill the CVTF on exhaust pipe to prevent it from emitting smoke or causing fires. If CVTF adheres, wipe it off completely.

• Always use specified CVTF. Using other fluid will cause malfunction.

1. Lift up the vehicle, and remove the CVTF drain plug.

2. Check the CVTF condition. CVTF > CONDITION CHECK">

3. Install the CVTF drain plug and gasket.

NOTE:

• Use a new gasket.

Tightening torque:

31 N·m (3.2 kgf-m, 22.9 ft-lb)

4. Remove the filler plug.

5. Add the specified fluid up to the filler plug hole lower section.

Specified fluid:

General Description > SPECIFICATION">

6. Temporarily tighten the filler plug.

7. Idle the engine to raise CVTF temperature to 35 — 45°C (95 — 113°F) on Subaru Select Monitor.

8. Operate the select lever in P > R > N > D and D > N > R > P to circulate CVTF with the engine idling.

CAUTION:

Pay special attention to the following operations as the engine is at idle.

9. With the select lever shifted to “P” range and the engine started, lift up the vehicle. Adjust the CVTF level and check for leakage. CVTF > ADJUSTMENT">

10. Replace with a new gasket, and attach the filler plug.

Tightening torque:

50 N·m (5.1 kgf-m, 36.9 ft-lb)

Inspection

Cvtf cooler (with warmer function)

Other materials:

Dtc b27a2 passenger side external antenna open
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B27A2 PASSENGER SIDE EXTERNAL ANTENNA OPENDTC detecting condition:When open circuit occurs in the harness between keyless access CM and passenger’s side front door outer h ...

Dtc p0304 cylinder 4 misfire detected
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0304 CYLINDER 4 MISFIRE DETECTEDDTC detecting condition:• Detected when two consecutive driving cycles with fault occur.• Immediately at fault recognition (A misfire which could damage catalyst oc ...

Inspection
LAN SYSTEM (DIAGNOSTICS) > General DescriptionINSPECTION1. INSPECTION WITHOUT USING CAN DIAGNOSTICBefore performing diagnosis, check the following items that might affect troubles of each module.1. Check the battery. Battery > INSPECTION">2. Check the fuse condition.Make sure that amp ...