Subaru Crosstrek Service Manual: Replacement

CAUTION:

• Directly after the vehicle has been running or the engine has been idling for a long time, the CVTF is hot. Be careful not to burn yourself.

• Be careful not to spill the CVTF on exhaust pipe to prevent it from emitting smoke or causing fires. If CVTF adheres, wipe it off completely.

• Always use specified CVTF. Using other fluid will cause malfunction.

1. Lift up the vehicle, and remove the CVTF drain plug.

2. Check the CVTF condition. CVTF > CONDITION CHECK">

3. Install the CVTF drain plug and gasket.

NOTE:

• Use a new gasket.

Tightening torque:

31 N·m (3.2 kgf-m, 22.9 ft-lb)

4. Remove the filler plug.

5. Add the specified fluid up to the filler plug hole lower section.

Specified fluid:

General Description > SPECIFICATION">

6. Temporarily tighten the filler plug.

7. Idle the engine to raise CVTF temperature to 35 — 45°C (95 — 113°F) on Subaru Select Monitor.

8. Operate the select lever in P > R > N > D and D > N > R > P to circulate CVTF with the engine idling.

CAUTION:

Pay special attention to the following operations as the engine is at idle.

9. With the select lever shifted to “P” range and the engine started, lift up the vehicle. Adjust the CVTF level and check for leakage. CVTF > ADJUSTMENT">

10. Replace with a new gasket, and attach the filler plug.

Tightening torque:

50 N·m (5.1 kgf-m, 36.9 ft-lb)

Inspection

Cvtf cooler (with warmer function)

Other materials:

Inspection
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Inhibitor SwitchINSPECTIONWhen the driving condition or starter motor operation is improper, first check the shift linkage for improper operation. If the shift linkage is functioning properly, check the inhibitor switch.1. Remove the clip (A) from the a ...

Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Air Breather HoseINSTALLATION1. FRONT DIFFERENTIAL SIDEInstall in the reverse order of removal.NOTE:Securely insert the air breather hose until the hose end contacts the catch of the pitching stopper bracket.2. TRANSMISSION CASE SIDEInstall in the rever ...

Dtc p0851 park/neutral switch input circuit low
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0851 PARK/NEUTRAL SWITCH INPUT CIRCUIT LOW1. AT MODELDTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:Improper idlingCAUTION:After servicing or replacing f ...