EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > PCV Hose
REMOVAL
CAUTION:
Do not remove except when the PCV hose is broken.
1. Disconnect the PCV hose A from the intake manifold and the PCV valve, and then remove the PCV hose A.

2. Remove the intake manifold. Intake Manifold > REMOVAL">
3. Remove the PCV hose B from the PCV connector.

Inspection
InstallationAdjustment
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Transfer ClutchADJUSTMENT1. Install the transfer clutch assembly to the extension case with the transfer driven gear shims and thrust bearings removed.2. Install the thrust bearing to the transfer driven gear.NOTE:Make sure to install in the right direc ...
Installation
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Main Shaft AssemblyINSTALLATION1. Attach the needle bearing and oil seal to the front of the main shaft assembly.NOTE:• Wrap the clutch splined section with vinyl tape to prevent damage to the oil seal.• Apply NICHIMOLY N-130 or the equivale ...
Removal
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Primary Speed SensorREMOVALCAUTION:Be sure to prevent water or oil from contacting the connector terminal of primary speed sensor. If adhesion occurs, replace with a new part.1. Remove the transmission assembly. Automatic Transmission Assembly > REM ...