Subaru Crosstrek Service Manual: Procedure

When parts related to the auto headlight beam leveler system are removed or replaced, perform the following procedures to initialize or reinitialize.

NOTE:

Before performing initialization or reinitialization, check the following:

• The vehicle is parked on a level surface.

• The inflation pressure of tires is correct.

• The vehicle does not have load.

• Vehicle’s fuel tank is fully filled.

• Refer to the following chart to determine whether to initialize or reinitialize.

• When the auto headlight beam leveler CM was replaced with a part from another vehicle.

• When suspension parts have been removed or replaced.

(Crossmember, front arm, sub frame, lateral link, housing, strut etc.)

• When the vehicle height sensor has been replaced or removed.

If the indicator does not flash three times or the headlight beam does not operate, it can be assumed that there is an open circuit or faulty wiring in the harness of the auto headlight beam leveler CM, vehicle height sensors or headlight assembly. Perform inspection and repair according to the inspection results, then perform initialization/reinitialization again.

• Initialization: Auto Headlight Beam Leveler System > PROCEDURE">

• Reinitialization: Auto Headlight Beam Leveler System > PROCEDURE">

1. Check that the indicator in the meter is flashing twice repeatedly.

2. Bounce the vehicle several times to normalize the suspension.

3. Make certain that someone is seated in the driver’s seat.

4. Turn the ignition switch to ON, and within 1.5 — 20 seconds, turn the headlight switch OFF > ON for three successive times.

5. Make sure that the indicator in the meter flashes three times and then turns OFF, indicating that initialization has been successfully completed. (At this time, the headlight beam drops once, and then returns to the original position.)

6. Perform beam adjustment for the headlight. Headlight Assembly > ADJUSTMENT">

1. Bounce the vehicle several times to normalize the suspension.

2. Make certain that someone is seated in the driver’s seat.

3. Turn the ignition switch to ON, and, within 1.5 — 10 seconds, turn the headlight switch OFF > ON five or more successive times.

4. Check that the headlight beam drops once, then returns to normal.

5. After confirming 4), turn the ignition switch to OFF within 30 seconds.

6. Turn the ignition switch to ON again, and, within 1.5 — 10 seconds, turn the headlight switch OFF > ON five or more successive times.

7. Make sure that the indicator in the meter flashes three times and then turns OFF, indicating that reinitialization has been successfully completed. (At this time, the headlight beam drops once, and then returns to the original position.)

8. Perform beam adjustment for the headlight. Headlight Assembly > ADJUSTMENT">

Inspection

Note

Other materials:

Inspection
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Reverse Check SleeveINSPECTION• Make sure the cutout of the reverse accent shaft is aligned with the opening in the reverse check sleeve.• Turn the cam by hand to check for smooth rotation.• Move the cam and shaft all the way toward th ...

Basic diagnostic procedure Procedure
ENGINE (DIAGNOSTICS)(H4DO) > Basic Diagnostic ProcedurePROCEDURE1. ENGINESTEPCHECKYESNO1.CHECK ENGINE START FAILURE.1) Ask the customer when and how the trouble occurred using the interview check list. Check List for Interview > CHECK">2) Start the engine.Does the engine start? Basic ...

Dtc u0422 invalid data received from body control module
LAN SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0422 INVALID DATA RECEIVED FROM BODY CONTROL MODULEDTC DETECTING CONDITION:Defective data was transmitted from body integrated unit.TROUBLE SYMPTOM:Cooperation control with body integrated unit does not operate ...