LIGHTING SYSTEM > Headlight Assembly
ADJUSTMENT
1. HEADLIGHT BEAM ADJUSTMENT
CAUTION:
• Turn off the light before adjusting the beam level of the light assembly - head. If it is necessary to inspect the beam level, do not keep the light on for two minutes or more.
• When blocking the light emitted from the headlight, use a light shield or equivalent.
Do not apply the tape on the lens or place the cloth over it. It may raise the temperature in the light and cause deformation/bubble formations of the plastic lens.
1. Before checking the beam level of the light assembly - head, be sure of the following:
• The area around the light assembly - head has not sustained any scratches, damage or other type of deformation.
• The vehicle is parked on a level surface.
• The inflation pressure of tires is correct.
• The vehicle does not have load.
• Vehicle’s fuel tank is fully filled.
2. Bounce the vehicle several times to normalize the suspension.
3. Make certain that someone is seated in the driver’s seat.
4. Measure the distance between the low beam bulb centers and the height of the bulb center.

(a) | High beam | (b) | Low beam |
5. Adjust the beam level of the light assembly - head (low beam).
(1) Place the vehicle with the front end facing to the measurement panel, then illuminate the low beam.

(A) | Vehicle center | (C) | 3 m (10 ft) | (D) | Height of headlight center |
(B) | Bulb center marking |
W mm (in) |
1,281 (50.44) |
(2) Adjust the low beam by turning the aiming screw.

RemovalDtc b1808 short in passenger s airbag (to +b)
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1808 SHORT IN PASSENGER’S AIRBAG (TO +B)Diagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Airbag main harness circuit is shorted to power supply.• Airbag module harness (passe ...
Summer tires
Summer tires are high-speed capability
tires best suited for highway driving under
dry conditions.
Summer tires are inadequate for driving
on slippery roads such as on snowcovered
or icy roads.
If you drive your vehicle on snow-covered
or icy roads, we strongly recommend the
use of winte ...
Operation
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Code(s) DisplayOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».3. On «Main Menu» display, select «Each System».4. On «Select System» display ...