Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: Windshield washer fluid

Windshield washer fluid warning light (type A)
Windshield washer fluid warning light (type A)

Windshield washer fluid warning light (type B)
Windshield washer fluid warning light (type B)

When there is only a small amount of washer fluid remaining, the windshield washer fluid warning light will illuminate.

When this occurs, refill the washer fluid.

Aluminum wheels
Aluminum wheels can be scratched and damaged easily. Handle them carefully to maintain their appearance, performance, and safety. When any of the wheels are removed and replaced for tire rota ...

Adding the windshield washer fluid
CAUTION Never use engine coolant as washer fluid because it could cause paint damage. Remove the washer tank filler cap, then add windshield washer fluid until it reaches the "FULL" mark on ...

Other materials:

Occupant detection system
The occupant detection system sensor is installed under the seat upholstery and monitors the physique and posture of the front passenger. Using this information, the occupant detection system determines whether the front passenger's SRS frontal airbag should be deployed or not. If the front ...

Dtc p0336 crankshaft position sensor "a" circuit range/performance
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0336 CRANKSHAFT POSITION SENSOR "A" CIRCUIT RANGE/PERFORMANCEDTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:• Engine stall• Failure ...

Removal
LIGHTING SYSTEM > Rear Turn Signal Light BulbREMOVAL1. CROSSTREK MODEL1. Disconnect the ground cable from battery. NOTE">2. Remove the light assembly - rear combination.CAUTION:Be careful not to damage the clips.(1) Release the bolts and clips, then pull out the light assembly - rear com ...

© 2016-2021 Copyright www.sucross.com