Subaru Crosstrek Owners Manual: Windshield washer
To wash the windshield, pull the wiper control lever toward you. The washer fluid sprays until you release the lever. The wipers operate while you pull the lever.
NOTE
Windshield washer fluid warning light (type A)
Windshield washer fluid warning light (type B)
The windshield washer fluid warning light illuminates when the washer fluid level in the tank has dropped to the lower limit. If the warning light illuminates, refill the tank with fluid. For the refilling procedure, refer to "Windshield washer fluid"
Wiper intermittent time control
When the wiper switch is in the "
"
position, turn the dial to adjust the operating
interval of the wiper. The operating
interval can be adjusted in several steps
from the shortest interval ...
Rear window wiper and washer switch
Washer (accompanied by wiper
operation)
Continuous
Intermittent
Off
Washer (accompanied by wiper
operation) ...
Other materials:
Audio set
Your vehicle may be equipped with one of
the following audio sets. Refer to the
pages indicated in this section for operating
details.
CAUTION
Always consult your SUBARU
dealer before installing a citizen
band radio or other transmitting
device in your vehicle. Such
devices may caus ...
Dtc p0967 pressure control solenoid "b" control circuit high
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0967 PRESSURE CONTROL SOLENOID "B" CONTROL CIRCUIT HIGHDTC detecting condition:Immediately at fault recognitionTrouble symptom:Engine speed increases abruptly, and can not star ...
Dtc p0717 input/turbine shaft speed sensor "a" circuit no signal
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0717 INPUT/TURBINE SHAFT SPEED SENSOR "A" CIRCUIT NO SIGNALDTC detecting condition:Immediately at fault recognitionTrouble symptom:• Standing start problems• Shock ...