Subaru Crosstrek Owners Manual: SRS airbag system servicing
WARNING
- When discarding an airbag module
or scrapping the entire vehicle
damaged by a collision, consult
your SUBARU dealer.
- The SRS airbag has no userserviceable
parts. Do not use
electrical test equipment on any
circuit related to the SRS airbag
system. For required servicing of
the SRS airbag, consult your
nearest SUBARU dealer. Tampering
with or disconnecting the
system's wiring could result in
accidental inflation of the SRS
airbag or could make the system
inoperative, which may result in
serious injury.
CAUTION
If you need service or repair in areas
indicated in the following list, have
the work performed by an authorized
SUBARU dealer. The SRS airbag
control module, impact sensors
and airbag modules are stored in
these areas.
- Under the center of the instrument
panel
- On both the right and left sides at
the front of the vehicle
- Steering wheel and column and
nearby areas
- Bottom of the steering column
and nearby areas
- Top of the dashboard on front
passenger's side and nearby
areas
- Each front seat and nearby area
- Inside each center pillar
- Inside each front door
- In each roof side (from the front
pillar to a point over the rear seat)
- Between the rear seat cushion
and rear wheel house on each
side
- Under the rear center seat
In the event that the SRS airbag is
deployed, replacement of the system
should be performed only by an authorized
SUBARU dealer. When the components
of the SRS airbag system are
replaced, use only genuine SUBARU
parts.
NOTE
In the following cases, contact your
SUBARU dealer as soon as possible.
- The front part of the vehicle was
involved in an accident in which only
the driver's SRS frontal airbag or both
driver's and front passenger's SRS
frontal airbags did not deploy.
- The pad of the steering wheel, the
cover over the front passenger's SRS
frontal airbag, or either roof side (from
the front pillar to a point over the rear
seat) is scratched, cracked, or otherwise
damaged.
- The center pillar, front door, rear
wheel house or rear sub frame, or an
area near these parts, was involved in
an accident in which the SRS side
airbag and SRS curtain airbag did not
deploy.
- The fabric or leather of either front
seatback is cut, frayed, or otherwise
damaged.
- The rear part of the vehicle was
involved in an accident in which no
SRS airbag was deployed.
SRS airbag system warning light (type B)
A diagnostic system continually monitors
the readiness of the SRS airbag system
(including front seatbelt pretensioners)
while the vehicle is being dri ...
WARNING
To avoid accidental activation of the
system or rendering the system
inoperative, which may result in
serious injury, no modifications
should be made to any components
or wiring of the S ...
Other materials:
Adjustment
PARKING BRAKE > Parking Brake Assembly (Rear Disc Brake)ADJUSTMENT1. SHOE CLEARANCE1. Return the lever assembly - hand brake completely.2. Loosen the adjusting nut, and make the cable free.3. Remove the adjusting hole cover (A) from the rear disc rotor.4. Insert a flat tip screwdriver (b) into th ...
Inspection
DRIVE SHAFT SYSTEM > Rear Hub Unit BearingINSPECTION1. Moving the rear tire up and down by hand, check there is no looseness in bearing, and check the wheel rotates smoothly.CAUTION:If there is unsmooth sliding operation or abnormal noise in the bearing, replace the rear hub unit bearing.2. Inspe ...
Preparation tool
HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS — SUBARU SELECT MONITOR 4Used for setting of each function and troubleshooting for electrical system.NOTE:For detailed operation procedures of Subaru Select Monitor ...
© 2016-2024 Copyright www.sucross.com