Subaru Crosstrek Service Manual: Specification
IGNITION(H4DO) > General Description
SPECIFICATION
Item | Specifications | |||
Ignition coil | Manufacturer and type | Hitachi: EIC-2230 | ||
Ignition system | Independent ignition coil | |||
Spark plug | Manufacturer and type | NGK: SILZKAR7B11 | ||
Thread size (diameter, pitch, length) | mm | 12, 1.25, 26.5 | ||
Spark plug gap | mm (in) | Standard | 1.0 — 1.1 (0.039 — 0.043) | |
Electrode | Center electrode: Iridium Ground electrode: Platinum | |||
Caution
IGNITION(H4DO) > General DescriptionCAUTION• Prior to starting work, pay special attention to the following:1. Always wear work clothes, a work cap, and protective shoes. Additionally, wear a ...
Component
IGNITION(H4DO) > General DescriptionCOMPONENT(1)Spark plug(2)Ignition coilTightening torque: N·m (kgf-m, ft-lb) T1:8.5 (0.9, 6.3) T2:17.5 (1.8, 12.9) ...
Other materials:
Inspection
CRUISE CONTROL SYSTEM > Cruise Control Command SwitchINSPECTION1. Measure the resistance between connector terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandard3 — 9CANCELSET/−RES/+All OFFApprox. 4,020 ?CANCELONLess than 1 ?SET/−ONApprox. 250 ?RES/+ONApp ...
Windshield washer
To wash the windshield, pull the wiper
control lever toward you. The washer fluid
sprays until you release the lever. The
wipers operate while you pull the lever.
NOTE
Windshield washer fluid warning light (type A)
Windshield washer fluid warning light (type B)
The windshield wash ...
Removal
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Turbine Speed SensorREMOVALCAUTION:Be sure to prevent water or oil from contacting the connector terminal of turbine speed sensor. If adhesion occurs, replace with a new part.1. Lift up the vehicle.2. Remove the harness connector from turbine speed sens ...