Subaru Crosstrek Owners Manual: OFF delay timer
The following lights have an automatic illumination function.
- dome light
- map light (type A)
- cargo area light
After being illuminated automatically, these lights remain on for several seconds and then gradually turn off under the following conditions
after all doors are closed (type A map light)
after the rear gate is closed (cargo area light)
While the lights are illuminated, if any of the following operations are performed, the lights turn off immediately.
- The ignition switch is turned from the "LOCK"/"OFF" position to the "ACC" or "ON" position.
- All doors and the rear gate are locked using the keyless access function (if equipped).
- All doors and the rear gate are locked using the remote keyless entry system.
The setting for the period of time in which the lights remain on (OFF delay timer) can be changed by a SUBARU dealer. Contact your SUBARU dealer for details. For models with multi function display, the setting can be changed by operating the multi function display. For details, refer to "Interior light off delay timer setting"
Map lights
Type A
Type B
To turn on the map light, push the switch.
To turn it off, push the switch again.
NOTE
For the type A map lights, although the
light switches are in the ON position,
the lig ...
Sun visors
To block out glare, swing down the visors.
To use the sun visor at a side window,
swing it down and move it sideways. ...
Other materials:
Dtc b27a7 trunk/rear gate internal antenna open
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B27A7 TRUNK/REAR GATE INTERNAL ANTENNA OPENDTC detecting condition:When open circuit occurs in the harness between keyless access CM and rear interior antenna.Trouble symptom:Ke ...
Using the jack
1. Park on a hard, level surface, whenever
possible, then stop the engine.
2. Apply the parking brake securely and
shift the shift lever in reverse (MT models)
or the select lever to the "P" (Park)
position (CVT models).
3. Turn on the hazard warning flasher
and unload all occupants and l ...
To arm the system using access
key/remote transmitter
1. Close all windows and the moonroof (if
equipped).
2. Remove the key from the ignition
switch (models without "keyless access
with push-button start system")/turn the
push-button ignition switch to the "OFF"
position (models with "keyless access with
push-button start system").
3. Open ...